Moxa Technologies OnCell G3100 - LED Indicators

OnCell G3100 Series Getting Started
2-8
LED Indicators
The LED indicators on the front panel of the OnCell series are described in the following table.
LED Name LED Color LED Function
PWR
Green DC Power is active.
off Power is off, or power error condition exists.
Tx
Green The serial port is transmitting data.
Off No data is being transmitted or received through the serial port.
Rx
Amber The serial port is receiving data.
off No data is being received through the serial port.
REG
Amber Registered with cellular provider (only for –JPS/JPN model)
off SIM slot not in used (only for –JPS/JPN model)
GSM
Amber GSM is connected.
off GSM is disconnected.
GRPS
Amber GPRS is connected
off GPRS is disconnected.
UMTS
Amber UMTS is connected.
off UMTS is disconnected.
HSPA
Amber HSPA is connected.
off HSPA is disconnected.
Ready
Green
Steady on: Software Ready.
Blinki
ng slowly (1 sec): The OnCell has been located by the OnCell Search
Utility.
off Power is off, or is booting up.
Fault
Red
Steady on: Booting up, or IP fault.
Blinking slowly (1 sec): Cannot get an IP address from the DHCP server
off Power is off, or there is no error condition.
Signal (3 LEDs) Green
Signal Level
(at least 2 LEDs must illuminated for data transmission)
ATTENTION
GSM LED
:
OFF
: Cannot register with cellular providers using GSM mode, due to the wrong PIN code, or no
cellular
provider available. Signal LEDs will also be off.
ON
: Registered with cellular provider. Signal LEDs will be on.
GPRS LED
:
OFF
:
Cannot register with cellular providers using GPRS mode, due to wrong PIN code (GSM/signal LEDs
of
f), no cellular provider available (GSM/signal LEDs off), wrong APN (GSM on/signal LEDs off), or
wrong username/password (GSM on/signal LEDs off).
ON
: Registered with cellular provider using GPRS mode. GSM/Signal LEDs will be on.
UMTS/HSPA LED:
OFF:
Cannot register with cellular providers using UMTS/HSPA mode due to the wrong PIN code
(UMTS
or HSPA/signal LEDs off), no cellular provider available (UMTS or HSPA/signal LEDs off), wrong
APN (UMTS or HSPA on/signal LEDs off), or wrong username/password (UMTS or HSPA
on/signal LEDs off).
ON:
Registered with cellular provider using UMTS/HSPA mode. UMTS or HSPA/Signal LEDs will be
on.