Multitel MX 250 - Page 185

DESCRIPTION
R NR RP
CHECK THAT PTO LIGHT TURNS ON WHEN THE POWER TAKE-
OFF IS ENGAGED
Checked □
CHECK THE OIL LEVEL IN THE TANK Done □
CHECK THE CARRIAGE LEVELLING SPIRIT BUBBLE Checked □
CHECK THE SEAL OF THE SUPPORTING JACKS Checked □
CHECK THE OPERATION OF THE STABILIZATION CONSENT
LIGHT
Checked □
CHECK THE OPERATION OF THE FEET LOCKING DEVICE WITH
BOOM RAISED
Checked □
CHECK THE LATERAL SLIDING BLOCKS Checked □
CHECK THE INTACTNESS OF THE SLIDING BLOCKS AND
THEIR FIXING SCREWS
Checked □
OPERATION OF 230V SOCKET (if installed) Checked □
CHECK THE HAND PUMP AND THE EMERGENCY LOWERING Checked □
CHECK THE ELECTRIC PUMP (if installed) Checked □
EMERGENCY PUSHBUTTON OPERATION Checked □
CHECK THE SEALS Done □
CHECK FOR PROPER OPERATION OF THE MOVEMENTS Checked □
EMERGENCY PUSHBUTTON OPERATION Done □
CHECK THE OPERATION OF THE BASKET LEVELLING Done □
(in the case of full opening gate) GREASE THE HINGES WITH
LUBRICATING SPRAY WITHOUT DISASSEMBLING
Done □
CHECK THE TORQUES Done □
MAKE SURE THERE ARE NO OIL LEAKS IN THE HYDRAULIC
SYSTEM OR JACKS
Done □
CHECK THE LIMITING DEVICE Done □
CHECK THE FASTENING OF THE LIMIT SWITCHES ON THE
BOOM HEAD
Checked □
MAKE SURE THE INSTRUCTIONS ON THE CONTROLS AND THE
WARNINGS ARE PRESENT
Done □
CHECK THE CONDITIONS OF THE OIL FILTER Checked □
LUBRICATION Done □
CLEANING Done □
R=REGULAR
NR=NOT REGULAR
RP=REPAIRED
BASKET
GENERAL CHECKS
CHECKS LOGBOOK
BOOM
OUTCOME
OUTRIGGERS
EXECUTION DATE
MONTHLY CHECK