156 Printing-related troubleshooting
"Loading a roll media" P. 22, "Setup 8: Origin" P. 80, "**>2: Adjust Print>" P. 63, "**>3: PF Adjust" P. 69, "Nozzle check and
cleaning" P. 31
White or black lines appear
on printed media.
Is the media loaded correctly?
‐ Load the media correctly.
Did you perform Print quality adjustment?
‐ Perform Print quality adjustment.
Did you perform Media feed adjustment?
‐ Perform Media feed adjustment.
Did you perform Print quality adjustment?
‐ Perform Print quality adjustment.
Did you perform Media feed adjustment?
‐ Perform Media feed adjustment.
Does the media contain moisture or are you using the creased or
wrinkled media?
- Replace it with the new media.
Are Nozzles in good condition?
‐ Perform Nozzle check.
Then if nozzle missing is found, conduct cleaning.
The printing position is
incorrect (some parts of
the media cannot be
printed on).
Is the media loaded correctly?
‐ Load the media correctly.
Did you set up the origin?
‐ Cancel or reset the settings of the origin.
Printing is blurred.
Is the media printed on the printing surface?
‐ Check the printing surface of the media and set it correctly.
To Next Page
Loading...
