50 Menus you can access while printing
You can change the micro adjustment value to correct media feeding for the currently print job.
• See the following related sections of Panel Setting Menus:
"**>3: PF Adjust" P. 69
You can save the change that you made on “Menu2: Pre Heater”, “Menu3: Platen Heater”, “Menu4: Dryer” and “Menu5: PF Micro
Adj.” in the currently selected user type.
Menu 5: PF Micro Adjustment
[1]
Tap .
[2]
Use or to change the value.
• Tap [Enter] to confirm the change.
Note
• The change made is applied to the current job only and is not saved in the
printer.
• To save the change in the user type currently selected, go to “Menu 6:
Backup”.
Menu 6: Backup
[1]
Tap .
[2]
Use or to select “Yes”.
•Tap [Enter].
The change is saved in the selected user type.
PF Micro Adjust:
(-5 - 5) 0.00%
To Next Page
Loading...
