Replacing Parts
High-Speed Encoder
NCR iTRAN 180es/300es/600 Operator’s Guide 4-25
11 Wind the ribbon onto the take up spool, then insert the spool into the
cassette.
12 Turn the takeup spool to tighten the ribbon.
Note: See the Ribbon Path Reference Drawing to make sure the ribbon is
installed correctly.
13 Hold the dancer arm back as you push the ribbon cassette back down
into the frame. Make sure that it is latched in place.
14 Pull the ribbon guide out of the track slot, then replace it in its storage
slot.
15 Close the encoder door.
To Next Page
Loading...