Replacing Parts
High-Speed Encoder
NCR iTRAN 180es/300es/600 Operator’s Guide 4-19
13 Insert the ribbon guide into the slot next to the track.
• Hold it so the left and right markings are correct.
• Angle it down on the right as you feed it into the slot.
• Push the ribbon guide down until its shoulders touch the track
Note: The cassette is not shown above in order to give a clearer view of
the track slot.
14 With the ribbon guide in place, insert the ribbon leader into the ribbon
slot. Push the leader straight down into this slot until you see the end of
the leader coming out below the ribbon cassette.
To Next Page
Loading...