4-84 System Configuration
No. Error message Action
7
Failed to create rollback image.
Try again. If the error persists, contact your service
representative because a failure may have occurred in
BMC.
8
Failed to erase.
Try again. If the error persists, contact your service
representative because a failure may have occurred in
BMC.
9
Unsupported format version:
Some update files may be corrupted. Obtain update
files again.
10 Failed to load the update image
file.
Some update files may be corrupted. Obtain update
files again.
11
Update has failed.
Try again. If the error persists, contact your service
representative because a failure may have occurred in
BMC.
12
Could not switch to the update
mode.
Try again. If the error persists, contact your service
representative because a failure may have occurred in
BMC.
13
Could not find the update targets:
Some update files may be corrupted. Obtain update
files again.
14
Invalid address:
Some update files may be corrupted. Obtain update
files again.
15
Writing has failed.
Try again. If the error persists, contact your service
representative because a failure may have occurred in
BMC.
16
Unsupported token is detected:
Some update files may be corrupted. Obtain update
files again.
17
Invalid segment information:
Some update files may be corrupted. Obtain update
files again.
18
Invalid data length:
Some update files may be corrupted. Obtain update
files again.
19
Failed to open the file: The specified file may not exist. Check the file name.
20 Failed to close the file: The specified file may be corrupted.
21
Invalid file checksum:
Some update files may be corrupted. Obtain update
files again.
22
Failed to parse files.
Some update files may be corrupted. Obtain update
files again.
23
Failed to parse files:
Some update files may be corrupted. Obtain update
files again.
24
Failed to load files:
Some update files may be corrupted. Obtain update
files again.
25
Could not find files:
Some update files may be corrupted. Obtain update
files again.
26
Failed to verify
Try again. If the error persists, contact your service
representative because a failure may have occurred in
BMC.
27 Update will be stopped because
interruption has occurred.
Check clients. A software program other than you are
using may have interrupted.
28
Online update is now being used.
Try again as necessary after online update performed
by other tool is completed.
29
Failed to acquire the current
revision.
The network may be busy. Try again. If the error
persists, contact your service representative because
a failure may have occurred in BMC.
30
Failed to acquire lines:
Some update files may be corrupted. Obtain update
files again.
To Next Page
Loading...
Need help?
General
