5-74 Installing and Using Utilities
NEC DianaScope
NEC DianaScope is software for remote management of the server.
For features and installation of NEC DianaScope, see “NEC DianaScope Online Document” in
“NEC EXPRESSBUILDER.”
TIPS:
To use NEC DianaScope with the server, appropriate server license is required.
- UL1198- 001E DianaScope Additional Server License (1)
License for managing one server.
- UL1198- 011E DianaScope Additional Server License (10)
License for managing ten servers.
ft Remote Management Card comes with one license of NEC DianaScope.
Notes
The online document provides general descriptions of overall severs to be remotely managed by
NEC DianaScope, but this section indicates notes that require special attention for remotely
managing this server using NEC DianaScope.
z The server can be managed remotely only when ft Remote Management Card is installed.
z When remotely managing this server from NEC DianaScope, only LAN connection is
available. Direct connection and connection via modem are not supported.
z NEC DianaScope cannot power off, power cycle or reset the server. The server does not
support such functions.
To Next Page
Loading...
