Maintenance 6-13
RELOCATING/STORING THE NEC Express5800/ft series
Follow the procedure below to relocate or store the server. (Users should not attempt to remove the
rack-mountable server from the rack assembly.)
CAUTION
Observe the following instructions to use the server safely. There are risks of
fire, personal injury, or property damage. See “PRECAUTIONS FOR SAFETY”
in Chapter 1 for details.
x Never attempt to lift the server only by yourself.
x Do not install the server in any place other than specified.
x Do not connect/disconnect any interface cable with the power cord of the
server plugged to a power source.
IMPORTANT:
If the server needs to be relocated/stored due to a change in the floor layout to a great
extent, contact the sales agent.
Make sure to make a backup copy of your valuable data in the hard disk, if any.
When moving the server with hard disks, make sure not to give a shock to the hard disks.
When storing the server, keep it under storing environment conditions (temperature: -10
to 55
°C, h
umidity: 20 to 80%, non-condensing).
1. Take a floppy disk and a CD-ROM out of the server, if any.
2. Power off the server.
3. Unplug the power cord of the server from a power outlet.
4. Remove all the cables from the server.
5. Remove all the mounted modules.
6. Remove the backplane and the rails from the rack cabinet.
7. Carry backplane, rails, and modules separately.
8. Protect the server with the shock-absorbing materials, and pack it securely.
IMPORTANT:
Check and adjust the system clock before operating the server again after relocating or storing
it.
If the server and the built-in optional devices are moved from a cold place to a warm place in a
short time, condensation will occur and cause malfunctions and breakdown when these are used
in such state.
When you start operating these equipments again after the transportation or the
storage, make sure to wait for a sufficient period of time to use them in the operating
environment.
If the system clock goes out of alignment remarkably as time goes by, though the system clock
adjustment is performed, contact your sales agent.
To Next Page
Loading...
Need help?
General
