4-6 System Configuration
Configuration Examples
The following describes examples of configuration required to use software-link features or for
system operations.
Link with Management Software
To control power supply of the server with NEC ESMPRO Manager via the network
<Using the LAN connector on the motherboard>
Select [Advanced]ĺ [Advanced Chipset Control]ĺ [Wake On LAN]ĺ [Enabled]
<Using the PCI LAN card>
Select [Advanced]ĺ [Advanced Chipset Control]ĺ [Wake On PME]ĺ [Enabled]ᴾ
ᴾ
UPS
To link power supply with the UPS
To power on the server when power is supplied from the UPS
Select [Server] - [AC-LINK] - [Power On].
To keep the server off-powered even when power is supplied from the UPS if the POWER
switch was used to power off
Select [Server] - [AC-LINK] - [Last State].
To keep the server off-powered even when power is supplied from the UPS
Select [Server] - [AC-LINK] - [StayOff].
Keyboard
To set Num Lock and key repeat
Select [Advanced] - [NumLock].
To Next Page
Loading...
