EasyManua.ls Logo

NEC Express5800 Series - Basic Server Operations

NEC Express5800 Series
358 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2-28 General Description
BASIC OPERATION
This section describes basic operation procedures of NEC Express5800/ft series.
Security lock (front door lock) (for tower model)
The security lock located at the front of this server locks the front door. Open the front door to
power on/off the server, operate the CD-ROM drive or 5.25-inch device, or install/remove a hard
disk drive on a 3.5-inch disk bay or CPU/IO module.
IMPORTANT:
The security lock can be unlocked only by the security keys shipped together.
Some software programs have commands to eject media on the tray of a CD-ROM drive or
device installed in a 5.25-inch device bay. Before you run any of these commands, make sure
the front door is open. If you run the command with the front door closed, the media on the
CD-ROM tray or 5.25-inch device bumps against the door and the server can get damaged.
To open the front door, unlock it and then hold the handle located in the right middle of the door
gently and pull it toward you. When you close the front door, it is recommended to lock it for
security reasons.
Front door unlocked
Front door locked

Table of Contents

Other manuals for NEC Express5800 Series

Related product manuals