Installing and Using Utilities 5-49
The maintenance operations in the table cannot be performed while collecting dump or updating
firmware. Wait until such processing is finished to perform the operations in the table.
The table below shows the component-specific maintenance functions executable from NEC
ESMPRO.
Dump
acquisition
Dump acquisition
during system
operation
Board switch
Component
RL R L R L
CPU module –
R: Remote. Executable from remote management PC by using NEC ESMPRO Manager
L: Local. Executable on local server by using Server Maintenance Utility
: Support
–: Not support
Change of primary SCSI bus
Component
RL
SCSI bus –
R: Remote. Executable from remote management PC by using NEC ESMPRO Manager
L: Local. Executable on local server by using Server Maintenance Utility
: Support
–: Not support
BMC firmware update
Component
RL
BMC
R: Remote. Executable from remote management PC by using NEC ESMPRO Manager
L: Local. Executable on local server by using Server Maintenance Utility
: Support
–: Not support
The table below shows the support of the whole system setup functions.
Quick dump
Automatic firmware
update
Automatic module start
Component
RLR L RL
Whole system –
–
–
R: Remote. Executable from remote management PC by using NEC ESMPRO Manager
L: Local. Executable on local server by using Server Maintenance Utility
: Support
–: Not support
To Next Page
Loading...
