NEC Express5800 Series User Manual

Installing and Using Utilities 5-53
Procedure in the Server Maintenance Utility
Start
1. Select the target component from the main window of the Server Maintenance Utility.
The screen of the target component appears.
2. Check the current state of the target component with the LEDs.
3. Select [Up] of the target component.
A certain time is required for the start.
The start result can be confirmed by the LEDs on the target component. The result of the
start operation is registered in the syslog.
Stop
Stop before replacing components.
1. Select the target component from the main window of the Server Maintenance Utility.
The screen of the target component appears.
2. Check the current state of the target component with the LEDs.
3. Select [Down] of the target component.
A certain time is required for the start.
The start result can be confirmed by the LEDs on the target component. The result of the
start operation is registered in the syslog.
Sample screen of Server Maintenance Utility
Main window
[CPU Module] screen

NEC Express5800 Series Specifications

General

Series	Express5800
Category	Server
Processor	Intel Xeon processors
Network	Gigabit Ethernet, 10 Gigabit Ethernet (Varies by model)
Operating System Support	Windows Server, Linux variants
Form Factor	Tower, Rackmount (1U, 2U, etc. - varies by model)
Memory	DDR4 ECC DIMM (Capacity varies by model)
Storage	SAS/SATA HDD/SSD, NVMe SSD (Configuration varies by model)