NEC Express5800 Series User Manual

7-20 Troubleshooting
Message Meaning Action
[FT LED: Off] The FC device is
not duplex.
[FT LED: Off] The FC device is
not duplexed.
Since removal of each device
was not completed, the driver
was not able to bind the
CPU/IO module.
The CPU/IO module cannot be
bound because devices have not
been comopletely removed yet.
HAS driver enabled use of
USB.
The USB queue timed out.
[FT LED: Off] South Bridge is
not doubled.
[FT LED: Off] The South Bridge
is not duplexed.
[FT LED: Off] PCI Express 0 is
not doubled.
[FT LED: Off] The PCI Express 0
is not duplexed.
[FT LED: Off] PCI Express 1 is
not doubled.
[FT LED: Off] The PCI Express 1
is not duplexed.
[FT LED: Off] CPU is not
doubled.
[FT LED: Off] The CPU is not
duplexed.
Removal of SCSI device was
not completed.
The removal processing of the
SCSI device has not been
completed.
[FT LED: Off] The doubleness
information about an I/O device
is not reported.
[FT LED: Off] The duplexity
information on the I/O device has
not been reported.
Take necessary actions
referring to
“Troubleshooting” in the
User’s Guide.
Service is stopped by the notice
of a stop.
The HAS management service is
stopped by an instruction from
the OS.
Snapshot dump is started. The dump service of the system
running in the duplex mode is
started.
Stop image dump is started. The dump service of the system
running in the simplex mode is
started.
Quick dump is started. The quick dump service is
started.
The server is operating
normally.
It failed in the doubleness
surveillance of a network card.
Failed to monitor duplexity of the
network card.
It failed in the doubleness
surveillance of a SCSI device.
Failed to monitor duplexity of the
SCSI device.
If the error occurs
frequently, contact your
sales agent.
It failed in the doubleness
surveillance of a FC device.
Failed to monitor duplexity of the
FC device.
If the error occurs
frequently, contact your
sales agent.
The error occurred in session
creation with client application.
Failed to create a session for
communication with client
applications.
Contact your sales agent.

NEC Express5800 Series Specifications

General

Series	Express5800
Category	Server
Processor	Intel Xeon processors
Network	Gigabit Ethernet, 10 Gigabit Ethernet (Varies by model)
Operating System Support	Windows Server, Linux variants
Form Factor	Tower, Rackmount (1U, 2U, etc. - varies by model)
Memory	DDR4 ECC DIMM (Capacity varies by model)
Storage	SAS/SATA HDD/SSD, NVMe SSD (Configuration varies by model)