8-12 System Upgrade
View the status of disks and confirm that the disks are added properly:
Command Action
1 New Disks
2 Remove Half Disk
3 Repair Disk
4 Remove Full Disks
5 Status(Raid)
6 Status(All Disks)
9 <= Return
Command:5
[Status(Raid)]
Name Partition Status Member
--------------------------------------------------
md6 resync=DELAYED (2)hadc7 (5)hadd7
md5 resync=DELAYED (2)hadc6 (5)hadd6
md4 resync=DELAYED (2)hadc5 (5)hadd5
md3 resync3.9% (2)hadc1 (5)hadd1
md1 / duplex (0)hada2 (3)hadb2
md2 duplex (0)hada3 (3)hadb3
md0 /boot duplex (0)hada1 (3)hadb1
TIPS:
If you attempt to start ftdiskadm more than once at a time, “Cannot start” is displayed. If this
message is displayed even when only one ftdiskadm is started, it may have been terminated
without clearing the information. In such a case, run ftdiskcleanup and then start ftdiskadm.
The trace log of ftdiskadm is recorded to the /var/log/ftdiskadm directory. If the files occupies a
large part of the disk space, delete them from the oldest.
Boot disks are inserted into the Slot0 and Slot3 normally. If you can only boot the system in the
simplex mode, insert a boot disk into the Slot0 and boot the system.
After the disk is expanded and the system is restarted, the name of the disk device used by
diskdump is changed. Refer to “DUMP INITIALIZATION” and modify
"/etc/sysconfig/diskdump.”
To Next Page
Loading...
Need help?
General
