2-16 General Description
(1) Power supply units
Power supply units supply DC power to the server.
(2) Cooling fan unit 2
(3) Lock springs
A lock spring prevents a power supply cord from disconnected from this device.
(4) AC inlets
A power cord is connected to this socket.
(5) Power supply unit LEDs
A power supply unit LED blinks in green when AC power is supplied via a power cord.
When the server is powered on, the LED illuminates in green (see page 2-27).
(6) Cooling fan LEDs
A cooling fan LED illuminates in green while a cooling fan unit is working normally. If the
fan unit has a problem, the LED illuminates in amber (see page 2-27).
(7) USB connectors
From left to right, USB2 and USB3. The connectors are used for connecting devices
supporting the USB1.1 interface.
(8) Monitor connector
This connector is used to connect a display device
(9) Management LAN port
This is a LAN port dedicated to management and can be used when a ft remote management
card is installed. The port is used when the remote management function or NEC DianaScope
is used (optional for 320Fa-L, 320Fa-LR models).
(10) LAN connector 1
This connector is used to connect to a network.
(11) LAN connector 2
This connector is used to connect to a network.
(12) LINK/ACT LEDs
A LINK/ACT LED indicates the LAN access status (see page 2-27).
(13) Speed LEDs
A speed LED indicates the transfer speed of the LAN (see page 2-27).
(14) PCI-X slot #1
64 bit 100MHz 3.3V PCI-X. A PCI board of low-profile type is attached to this slot.
(15) PCI-X slot #2
64 bit 100MHz 3.3V PCI-X. A PCI board of low-profile type is attached to this slot.
To Next Page
Loading...
