General Description 2-37
To remove the CD-ROM, press the CD-tray-eject button as you did
in setting the CD-ROM.
ᴾ
When the access LED illuminates in orange, it indicates the
CD-ROM is being accessed. Make sure the access LED is not
illuminating in orange before you press the CD-tray-eject button.
Press the locking part in the center of the tray and pick the CD-ROM gently. When you have
removed the CD-ROM, push the tray to the drive-closed position.
When you cannot eject a CD-ROM
When you cannot eject the CD-ROM from the server even by pressing the eject button, follow the
steps below to eject it:
1. Press the POWER switch to power off this server (i.e. the POWER/SLEEP LED is off).
2. Use a metal pin of about 1.2 mm in diameter and 100 mm
long (alternatively, you can use a fairly large paper clip after
straightening). Insert it gently into the manual release hole
located at the low front side of the server until the tray is
ejected.
ᴾ
IMPORTANT:
Do not use a toothpick, plastic pin, or other breakable
objects.
If you cannot eject the CD-ROM by following the steps above, contact your sales agent.
3. Hold the tray and pull it out.
4. Take out the CD-ROM.
5. Push the tray back.
To Next Page
Loading...
