NETGEAR GS752TP - Page 117

Configuring Switching Information
117
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
The following screen displays:
2. In the VLAN ID field, select the VLAN IDs for which MLD snooping is enabled.
3. In the Admin Mode field, enable MLD Snooping for the specified VLAN ID.
4. In the Fast Leave
Admin Mode field, enable or disable the MLD Snooping Fast Leave
mode for the specified VLAN ID.
5. In the
Group Membership Interval field, enter the value for the group membership interval
of MLD Snooping for the specified VLAN ID.
The value is calculated as the Multicast Router Expiry Time + ½ Maximum Response
T
ime.
6. In the Maximum Response T
ime field, set the value for maximum response time of MLD
snooping for the specified VLAN ID.
The valid range is 1–20 seconds.
7. In the Multicast Router Expiry Time field, enter the value for multicast router expiry time
of MLD snooping for the specified VLAN ID.
The valid range is 3 – 3610 seconds.
This value is calculated as: 2 * QI + ½ Maximum
Response Time, where:
QI = (Group Membership Interval – Maximum Response
Time) / 2
8. Click ADD to enable MLD Snooping on the specified VLAN.
9. Click APPL
Y to send the updated configuration to the switch.
Configuration changes take place immediately.