NETGEAR GS752TP - LLDP Port Settings

Configuring System Information
58
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
LLDP Port Settings
Use the LLDP Port Settings screen to specify LLDP parameters that are applied to a specific
interface.
 To configure LLDP port settings:
1. Select System
 LLDP  Advanced  LLDP Port Settings.
The following screen displays:
2. Select the check box next to one or more ports.
3. Specify the following LLDP port settings:
• Interface. Specifies the port affected by these parameters.
• Admin Status. Select the status for transmitting and receiving LLDP packets:
• Tx Only. Enable only transmitting LLDP PDUs on the selected ports.
• Rx Only. Enable only receiving LLDP PDUs on the selected ports.
• Tx & Rx. Enable both transmitting and receiving LLDP PDUs on the selected
ports.
This value is the default value.
• Disabled. Do not transmit or receive LLDP PDUs on the selected ports.
• Management IP
Address. Select whether to advertise the management IP address
from the interface.
The possible values are:
• Stop Advertise. Do not advertise the management IP address from the interface.
• Auto Advertise.
Advertise the current IP address of the device as the
management IP address.
• Notification.
When notifications are enabled, LLDP interacts with the trap manager to
notify subscribers of remote data change statistics. The default is Disabled.