EasyManuals Logo

NETGEAR GS752TP User Manual

NETGEAR GS752TP
275 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
Getting Started
12
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
Discover a Switch in a Network with a DHCP Server
This section describes how to set up your switch in a network that has a DHCP server. The
DHCP client on the switch is enabled by default. When you connect it to your network, the
DHCP server automatically assigns an IP address to your switch. To discover the IP address
automatically assigned to the switch, use the Smart Control Center.
To install the switch in a network with a DHCP server, use the following steps:
1. Connect the switch to a network with a DHCP server.
2. Power on the switch by connecting its power cord.
3. Install the Smart Control Center on your computer
.
4. Start the Smart Control Center.
5. Click Discover for the Smart Control Center to find your switch.
A screen similar to the one shown below is displayed.
6. Make a note of the displayed IP address assigned by the DHCP server.
You need this value to access the switch directly from a web browser (without using the
Smart Control Center).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR GS752TP and is the answer not in the manual?

NETGEAR GS752TP Specifications

General IconGeneral
Switch typeManaged
Switch layerL3
Quality of Service (QoS) supportYes
Number of multicast groups filtered1024
Fiber optic connectorSFP
SFP module slots quantity4
Basic switching RJ-45 Ethernet ports typeGigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity48
10G support-
Number of VLANs256
Networking standardsIEEE 802.1D, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3af, IEEE 802.3at, IEEE 802.3x
Copper ethernet cabling technology1000BASE-T, 100BASE-T, 10BASE-T
DHCP featuresDHCP client
MAC address table8000 entries
Packet buffer memory8 MB
Number of static routes32
Supported network protocolsIPv4, IPv6, TFTP, SNTP, TACACS+
Power consumption (typical)384 W
SafetyCE, CSA, UL
Product colorGray
Electromagnetic compatibilityCE, FCC, Class A EN 55022, Class A C-Tick, EN 50082-1, EN 55024, CCC
Mean time between failures (MTBF)220447 h
Heat dissipation1750.70 BTU/h
Operating altitude0 - 3000 m
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 55 °C
Storage relative humidity (H-H)0 - 95 %
Operating relative humidity (H-H)10 - 90 %
Total Power over Ethernet (PoE) budget15.4 W
Power over Ethernet plus (PoE+) ports quantity8
Cables includedAC
Weight and Dimensions IconWeight and Dimensions
Depth316 mm
Width440 mm
Height43 mm
Weight5100 g

Related product manuals