NETGEAR GS752TP User Manual

Getting Started
15
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
7. Select the Disabled radio button to disable DHCP.
8. Enter the static switch IP address, gateway IP address, and subnet mask for the switch and
type your password.
Tip: You must enter the current password every time you use the Smart
Control Center to update the switch setting.
The default password is
password.
9. Click APPL
Y
to configure the switch with the network settings.
Ensure that your computer and the switch are in the same subnet. Make a note of these
settings for later use.
Configure the Network Settings on the Administrative
System
If you do not use the Smart Control Center to configure the switch network information, you
can connect directly to the switch from the administrative system installed on your computer.
The IP address of the administrative system must be in the same subnet as the default IP
address on the switch. For most networks, this means you must change the IP address of the
administrative system to be on the same subnet as the default IP address of the switch
(192.168.1.1).
To change the IP address on an administrative system running a Windows operating system,
open the Internet Protocol (TCP/IP) Properties screen that you access from each local area
connection, as shown in the following screen.
Y
ou need Windows Administrator privileges to
change these settings.

NETGEAR GS752TP Specifications

General

Switch type	Managed
Switch layer	L3
Quality of Service (QoS) support	Yes
Number of multicast groups filtered	1024
Fiber optic connector	SFP
SFP module slots quantity	4
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	48
10G support	-
Number of VLANs	256
Networking standards	IEEE 802.1D, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3af, IEEE 802.3at, IEEE 802.3x
Copper ethernet cabling technology	1000BASE-T, 100BASE-T, 10BASE-T
DHCP features	DHCP client
MAC address table	8000 entries
Packet buffer memory	8 MB
Number of static routes	32
Supported network protocols	IPv4, IPv6, TFTP, SNTP, TACACS+
Power consumption (typical)	384 W
Safety	CE, CSA, UL
Product color	Gray
Electromagnetic compatibility	CE, FCC, Class A EN 55022, Class A C-Tick, EN 50082-1, EN 55024, CCC
Mean time between failures (MTBF)	220447 h
Heat dissipation	1750.70 BTU/h
Operating altitude	0 - 3000 m
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 55 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 90 %
Total Power over Ethernet (PoE) budget	15.4 W
Power over Ethernet plus (PoE+) ports quantity	8
Cables included	AC

Weight and Dimensions

Depth	316 mm
Width	440 mm
Height	43 mm
Weight	5100 g