NETGEAR GS752TP - Configure IP Settings

Configuring Routing
127
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
Configure IP Settings
Use the IP Configuration screen to configure routing parameters for the switch.
 To access the IP Configuration screen:
1. Select Routing
 IP > IP Configuration.
The following screen displays:
Default Time to Live displays the default value inserted into the Time-To-Live field of the
IP header of datagrams originated by the switch, if a TTL value is not supplied by the
transport layer protocol.
Maximum Next Hops displays the maximum number of hops supported by the switch.
2. Next to Routing Mode, select Enable or Disable.
If you select Disable, the switch is in switch mode.
Y
ou must enable routing for the switch before you can route through any of the
interfaces. Routing is enabled or disabled per VLAN interface. The default value is router
mode.
3. Click APPLY to send the updated configuration to the switch.
Switching a routing mode requires a reboot.
The configuration file is not deleted during
the reboot.