NETGEAR GS752TP - Trap Configuration

Configuring System Information
52
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
Trap Configuration
This screen displays an entry for every active Trap Receiver.
 To configure SNMP trap settings:
Select System
 SNMP  SNMP v1/v2  Trap Configuration.
The following screen displays:
 To add a host that receives SNMP traps:
1. Enter trap configuration information in the following fields:
• Recipients IP. The address in x.x.x.x format to receive SNMP traps from this device.
• Version. The trap version used by the receiver.
• SNMP v1. Uses SNMP v1 to send traps to the receiver.
• SNMP v2. Uses SNMP v2 to send traps to the receiver.
• Community String. The community string for the SNMP trap packet sent to the trap
manager.
This community string can be up to 16 characters and is case-sensitive.
2. Click ADD.
Configuration changes take effect immediately.
 To modify information about an existing SNMP recipient:
1. Select the check box next to the recipient, and change the desired fields.
2. Click APPL
Y.
Configuration changes take effect immediately
.