NETGEAR GS752TP - Trap Flags; SNMP Supported Mibs

Configuring System Information
53
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
Trap Flags
Use the Trap Flags screen to enable or disable traps the switch can send to an SNMP
manager. When the condition identified by an active trap encounters the switch, a trap
message is sent to any enabled SNMP trap receivers, and a message is written to the trap
log.
 To configure the trap flags:
1. Select System
 SNMP  SNMP v1/v2  Trap Flags.
The following screen displays:
2. From the All field, globally enable or disable activation of all traps by selecting the
corresponding button.
The factory default is Enable.
3. From the Authentication field, enable or disable activation of authentication failure traps by
selecting the corresponding button.
The factory default is Enable.
4. Click APPL
Y.
Configuration changes take effect immediately
.
SNMP Supported MIBs
The screen allows you to view a list of the supported MIBs.