NETGEAR GS752TP - Ipv6 Network Configuration

Configuring System Information
29
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
Note: Make sure that the PVID of at least one port that is a port of the VLAN
is the same as the management VLAN ID. For information about
creating VLANs and configuring the PVID for a port, see VLANs on
page 82.
The management VLAN has the following requirements:
• Only one management VLAN can be active at a time.
• When a new management VLAN is configured, connectivity through the existing
management VLAN is lost.
• The management station must be reconnected to the port in the new management
VLAN.
5. Click APPL
Y to apply the changes to the system.
IPv6 Network Configuration
Use the IPv6 Network Configuration screen to configure the IPv6 network interface, which is
the logical interface used for in-band connectivity with the switch through all of the switch's
front-panel ports. The configuration parameters associated with the switch's network
interface do not affect the configuration of the front-panel ports through which traffic is
switched or routed.
To access the switch over a IPv6 network, you must initially configure the switch with IPv6
information (IPv6 prefix, prefix length, and default gateway). IPv6 can be configured using
IPv6 autoconfiguration.
When in-band connectivity is established, IPv6 information can be changed using any of the
following:
• SNMP-based management
• Web-based management
 To configure the global settings for an IPv6 Interface:
1. Select System
 Management  IPv6 Network Configuration.