EasyManuals Logo

NETGEAR GS752TP User Manual

NETGEAR GS752TP
275 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
Configuring Switching Information
77
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
Link Aggregation Groups
Link aggregation groups (LAGs), which are also known as port channels, allow you to
combine multiple full-duplex Ethernet links into a single logical link. Network devices treat the
aggregation as if it were a single link, which increases fault tolerance and provides load
sharing. You assign the LAG VLAN membership after you create a LAG. The LAG by default
becomes a member of the management VLAN.
A LAG interface can be either static or dynamic, but not both. All members of a LAG must
participate in the same protocols.
A static port channel interface does not require a partner
system to be able to aggregate its member ports.
Static LAGs are supported. When a port is added to a LAG as a static member
, it does not
transmit or receive LAGPDUs. This switch supports eight LAGs.
From the LAGs menu, you can access features described in the following sections:
LAG Configuration
LAG Membership
LACP Configuration
LACP Port Configuration
LAG Configuration
Use the LAG Configuration screen to group one or more full-duplex Ethernet links to
aggregate together to form a link aggregation group, which is also known as a port channel.
The switch treats the LAG as if it were a single link.
To configure LAG settings:
1. Select Switching
LAG Basic LAG Configuration.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR GS752TP and is the answer not in the manual?

NETGEAR GS752TP Specifications

General IconGeneral
Switch typeManaged
Switch layerL3
Quality of Service (QoS) supportYes
Number of multicast groups filtered1024
Fiber optic connectorSFP
SFP module slots quantity4
Basic switching RJ-45 Ethernet ports typeGigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity48
10G support-
Number of VLANs256
Networking standardsIEEE 802.1D, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3af, IEEE 802.3at, IEEE 802.3x
Copper ethernet cabling technology1000BASE-T, 100BASE-T, 10BASE-T
DHCP featuresDHCP client
MAC address table8000 entries
Packet buffer memory8 MB
Number of static routes32
Supported network protocolsIPv4, IPv6, TFTP, SNTP, TACACS+
Power consumption (typical)384 W
SafetyCE, CSA, UL
Product colorGray
Electromagnetic compatibilityCE, FCC, Class A EN 55022, Class A C-Tick, EN 50082-1, EN 55024, CCC
Mean time between failures (MTBF)220447 h
Heat dissipation1750.70 BTU/h
Operating altitude0 - 3000 m
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 55 °C
Storage relative humidity (H-H)0 - 95 %
Operating relative humidity (H-H)10 - 90 %
Total Power over Ethernet (PoE) budget15.4 W
Power over Ethernet plus (PoE+) ports quantity8
Cables includedAC
Weight and Dimensions IconWeight and Dimensions
Depth316 mm
Width440 mm
Height43 mm
Weight5100 g

Related product manuals