NETGEAR GS752TP User Manual

Configuring Switching Information
76
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
4. Configure or view the settings:
• Description. Enter the description string to be attached to a port. The string can be
up to 64 characters in length.
• Port Type. This field is blank for most ports. Otherwise, the possible values are:
• Mirrored. Indicates that the port is a source mirroring port.
• Probe. Indicates that the port is a destination mirroring port.
• LAG. Indicates that the port is a member of a link aggregation trunk. For more
information, see
Link Aggregation Groups on page 77.
• Admin Mode. Select the menu the port control administration state, which can be one
of the following:
• Enable.
The port can participate in the network (default).
• Disable. The port is administratively down and does not participate in the network.
• Port Speed
. Select the port’s speed and duplex mode. If you select
Auto, the
autonegotiation process sets the duplex mode and speed. The port’s maximum
capability (full duplex and 1000 Mbps) is advertised. Otherwise, your selection
determines the port’s duplex mode and transmission rate. The factory default is Auto.
• Physical Status. Indicates the physical port’
s speed and duplex mode.
• Link Status
. Indicates whether the link is up or down.
• MAC Address. Displays the physical address of the specified interface.
• ifIndex.
The ifIndex of the interface table entry associated with this port. If the
interface field is set to
All, this field is blank.
5. Click APPLY to apply the changes to the system.

NETGEAR GS752TP Specifications

General

Switch type	Managed
Switch layer	L3
Quality of Service (QoS) support	Yes
Number of multicast groups filtered	1024
Fiber optic connector	SFP
SFP module slots quantity	4
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	48
10G support	-
Number of VLANs	256
Networking standards	IEEE 802.1D, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3af, IEEE 802.3at, IEEE 802.3x
Copper ethernet cabling technology	1000BASE-T, 100BASE-T, 10BASE-T
DHCP features	DHCP client
MAC address table	8000 entries
Packet buffer memory	8 MB
Number of static routes	32
Supported network protocols	IPv4, IPv6, TFTP, SNTP, TACACS+
Power consumption (typical)	384 W
Safety	CE, CSA, UL
Product color	Gray
Electromagnetic compatibility	CE, FCC, Class A EN 55022, Class A C-Tick, EN 50082-1, EN 55024, CCC
Mean time between failures (MTBF)	220447 h
Heat dissipation	1750.70 BTU/h
Operating altitude	0 - 3000 m
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 55 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 90 %
Total Power over Ethernet (PoE) budget	15.4 W
Power over Ethernet plus (PoE+) ports quantity	8
Cables included	AC

Weight and Dimensions

Depth	316 mm
Width	440 mm
Height	43 mm
Weight	5100 g