NETGEAR GS752TP User Manual

Maintenance
239
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
The initial value is blank. This information is not retained across a power cycle. The
maximum number of characters in a name is 160.
3. Optionally, configure the following settings:
• In the Count field, specify the number of pings to send. The valid range is 1–15.
• In the Interval (secs) field, specify the number of seconds between pings sent. The
valid range is 1–60.
• In the Size field, specify the size of the ping (ICMP) packet to send. The valid range is
0–65507.
• The Results field displays the result after the switch sends a ping request to the
specified address.
4. Click APPLY to send the ping.
The switch sends the number of pings specified in the Count
field, and the results are displayed in the Results field.
• If a reply to the ping is received, you see “Reply From IP/Host: icmp_seq = 0. time =
xx usec.
Tx = x, Rx = x Min/Max/Avg R
TT = x/x/x msec.”
• If a reply to the ping is not received, you see “Reply From IP/Host: Destination
Unreachable. Tx = x, Rx = 0 Min/Max/Avg R
TT = 0/0/0 msec.”
Ping IPv6
Use the Ping IPv6 screen to send a ping request to a specified host name or IPv6 address.
This checks whether the switch can communicate with a particular IPv6 station. When you
click the APPLY button, the switch sends three pings, and the results are displayed.
 To configure the settings and ping a host on the network:
1. Select Maintenance
 Troubleshooting  Ping IPv6.
The following screen displays:

NETGEAR GS752TP Specifications

General

Switch type	Managed
Switch layer	L3
Quality of Service (QoS) support	Yes
Number of multicast groups filtered	1024
Fiber optic connector	SFP
SFP module slots quantity	4
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	48
10G support	-
Number of VLANs	256
Networking standards	IEEE 802.1D, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3af, IEEE 802.3at, IEEE 802.3x
Copper ethernet cabling technology	1000BASE-T, 100BASE-T, 10BASE-T
DHCP features	DHCP client
MAC address table	8000 entries
Packet buffer memory	8 MB
Number of static routes	32
Supported network protocols	IPv4, IPv6, TFTP, SNTP, TACACS+
Power consumption (typical)	384 W
Safety	CE, CSA, UL
Product color	Gray
Electromagnetic compatibility	CE, FCC, Class A EN 55022, Class A C-Tick, EN 50082-1, EN 55024, CCC
Mean time between failures (MTBF)	220447 h
Heat dissipation	1750.70 BTU/h
Operating altitude	0 - 3000 m
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 55 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 90 %
Total Power over Ethernet (PoE) budget	15.4 W
Power over Ethernet plus (PoE+) ports quantity	8
Cables included	AC

Weight and Dimensions

Depth	316 mm
Width	440 mm
Height	43 mm
Weight	5100 g