NETGEAR GS752TP - Service Configuration

Configure Quality of Service
155
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
• Committed Rate. The committed rate is the average bandwidth in bits per seconds
specified in kilobits-per-second (Kbps) and is an integer from 100 to 1000000.
• Committed Burst Size. The committed burst size is the maximum amount of traf
fic
allowed in one burst (in bytes) and is an integer from 3000 to 19173960.
Note: The Token Bucket algorithm is used, in which the committed rate is
the rate at which the bucket is filled, and the committed burst size is
the size of the bucket. This means that the committed burst size is the
maximum size of a burst that can be sent.
• Conform Action. Determines what happens to packets that are considered
conforming (below the police rate). Select one of the following actions:
• Send. (Default) These packets are presented unmodified by Dif
fServ to the
system forwarding element.
• Drop. These packets are immediately dropped.
• Mark CoS. These packets are marked by Dif
fServ with the specified CoS value
before being presented to the system forwarding element. This selection requires
that the Mark CoS value field be set.
• Mark IP DSCP. These packets are marked by Dif
fServ with the specified DSCP
value before being presented to the system forwarding element. This selection
requires that the DSCP value field be set. If you select Other, enter a custom
value in the DSCP Value field that appears.
• V
iolate Action. Determines what happens to packets that are considered
non-conforming (above the police rate). Select one of the following actions:
• Send
. These packets are presented unmodified by DiffServ to the system
forwarding element.
• Drop. These packets are immediately dropped.
4. Click APPLY
to send the updated configuration to the switch.
Configuration changes take effect immediately.
Service Configuration
Use the Service Configuration screen to activate a policy on an interface.
 To configure DiffServ policy settings on an interface:
1. Select QoS
 DiffServ  Advanced  Service Configuration.