NETGEAR GS752TP - Page 148

Configure Quality of Service
148
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
The following screen displays:
All the previously defined classes are displayed.
2. Enter the new class name.
3. Select the class type, and click Add.
The switch supports only the Class Type value All, which means all the various match
criteria defined for the class must be satisfied for a packet match.
All signifies the logical
AND of all the match criteria.
4. Click APPLY to save the class.
T
o configure this class, proceed to To configure a class:
Use the buttons at the bottom of the screen to perform the following:
• To remove a class, select the check box beside the class name, then click DELETE.
• T
o cancel the configuration you just entered, click CANCEL.
 To configure a class:
1. Select QoS
 DiffServ  Advanced  IPv6 Class Configuration.