Configuring Switching Information
81
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
The following screen displays:
2. Select the check box next to the port to configure.
You can select multiple ports to apply the same settings to all selected ports.
Note: You cannot select ports that are not participating in a LAG.
3. Configure the LACP Priority value for the selected port.
The valid range is 0–255. The default value is 128.
4. Configure the administrative LACP Timeout value.
• Long
. Specifies a long time-out value.
• Short. Specifies a short time-out value.
5. Click APPLY to send the updated configuration to the switch.
Configuration changes take effect immediately
.
To Next Page
Loading...
