DVR Server Manual
【Sensor Inputs(DI)】Display the number of sensors (DI). The sensor
input of both analog and IP cameras included.
【Sensor outputs(DO)】Display the number of alarms(DO). The sensor
output of both analog and IP cameras included.
【Audio Monitoring】Select real-time monitoring audio or not.
【Use E-Map】Select use Electron Map or not.
【Camera Sequencing Interval】Set auto-split changing interval time. If
you select”—“, you can’t Press button to switch among all playing
cameras in current windows in sequence even when the current partition
number is less than the total channels.
【DI/DO Port】Select sensor/alarm driver connecting port, it must be
different from PTZ Port. If you do not use alarm input, you can close this
function. To avoid conflicting with the PTZ port, you should set and use
different ports for these two functions.
【Keyboard Shield】When it is enable, functions of some system keys
will be disabled.
【Save Log for() Days】Log save days(max 100 days).
【DI/DO Device】Select receive alarm device type. When you change the
type of alarm device, you should reboot the system to update the device
information in DI/DO Control Panel.
Note:
Currently, system supports following NV serials DI/DO devices: NV7608,
NV7609, NV7616, NV7616B, NV7632 and NV7632B. NV7632 includes two
NV7616 (or combination of NV 7608 and NV 7616), and NV7632B includes
two NV7616B. When you select these two selections you must set their
decoder address as 1 and 2, and they should be connected with PC through
RS 485 converter after they connected parallel with each other.
【Alarm Beep】Select disable or enable from drop-down list. If select
“enable”, when there is an alarm, system will make beep voice.
【Alarm camera popup interval】Set the interval of alarm camera, if you
select“—”,you can’t select function
“Start Alarm Popup”.
【POS Function】Set the POS function disable or not. The function is
available to both local board card camera and IP camera now. For details,
please refer to our POS manual.
【Date Format】Select the way to display date. It decides the date display
mode of DVR system, including the information panel on the main screen, the
date panel of the playback window and OSD date in video.
【Default Camera type】Set the default mode of video from PAL and
NTSC, it is available when the input video is lost and for the decoder to
playback local video to TV Wall.
54
To Next Page
Loading...