DVR Server Manual
【ACU Function】Set the ACU function disable or not
【Time Format】Select time format from the drop-list. After you change
the format it will affect the OSD format, information in information display panel
and file lists.
【Grab picture save to 】Select the path to save the captured pictures.
【Preview Split Mode】Select window split mode for DVR between
“Normal Mode” and “Wide Screen”. You should re-select the view window
number to refresh the window split mode status.
【HS Card 4CIF Mode 】Select the HS Card 4CIF Mode function disable
or enable.
【Auto Upgrade】Select the Auto Upgrade disable or enable, if you select
enable ,you should enter the Auto Upgrade Setup to set the Server IP ,Port
and the Auto Upgrade Date.
【Language】Select one kind of language to use. Generally speaking,
there is “English” only. But we can add some other kinds of language
according to your requirement.
【Display Resolution】Select display resolution among Auto, 1024*768,
1280*768, 1280*1024, 1366*768, 1440*900, 1600*900, 1680*1050 and
1920*1080. When Auto is selected, the software will adjust its display
resolution according to the resolution of desktop. When the desktop resolution
is any of the resolution mentioned above, it will be displayed as that resolution.
If it’s not any of them, the software will select the closest one. For example,
when the desktop resolution is set as 1280*960 and Auto is selected, then,
DVR will be displayed as 1280*768. It will take effect after the software is
restarted.
【Dual Monitor Function】Select to disable or enable dual monitor
function.
Note:
If you want to use dual monitor, you have to make sure the hardware and
the system support the dual monitor first. When there are more than two
monitors connected and all the settings are done, the software can realize
dual-monitor function automatically after you enabled this function. For more
details about dual-monitor, please refer to Dual Monitor User Manual.
2.1.2 Network Setup
【Remote Connection】Select using network or not. If select “disable”, it
will not permit any client connect this DVR system.
【Remote Connect Port】Select remote connection port for Clients.
【Remote buffer Priority】Select among Smooth, Normal and Realtime.
“Smooth” demands there is large buffer in the system. “Realtime” demands
there is enough bandwidth. Otherwise, the data will be off and on when it is
55
To Next Page
Loading...