6-26
To create a CallistoPrinter account for your network do the following.
- On the Operator panel touch the Settings icon.
- Select the Device Settings->Networking->Password Protection
- On the Password Protection panel that appears, check Password Protection.
- Enter and Confirm a password for the CallistoPrinter account.
- Select the Apply button.
This will now allow the printer to be setup and the printer driver to install on computers
attached to your network by entering the CallistoPrinter account and the password you created
when prompted during printer setup.
Remember this password. If you are installing multiple printers on the network, the other
printers will need these same steps performed.
Figure 6-6. Password Protection for the Callisto
To Next Page
Loading...
Need help?
General