9-74
Figure 9-4. Web Server: Printhead Height
Settings
The Callisto Web Server contains commonly used printer Settings, also found on the printer
operator panelPrint Parameters, Print Speed and Printhead Height pages offer the ability to set
the same parameters as the operator panel.
Print Parameters that are settable on this page include the parameters that can be overridden
from values passed in by the printer driver. These include Print Mode, Mark Mode, Gap
Between Labels (web press mode) and Mark Adjustment. In most circumstances these values
will not need to be changed. These values would only need to be overridden in cases where
unusual, complicated or outdated network, versions of windows or printing applications are
keeping the driver values from being properly sent to the printer.
Print Speed may be overridden if desired. The speed at which labels can be printed on the
Callisto printer depends of a variety of factors including print quality, file complexity and file
width. Copies can be printed at faster speeds than sequenced labels.
Printhead Height, discussed in the previous section, should usually be set by the printer driver.
However some label media may require special adjustments to the printhead height. Set this
value in the web server or on the printer operator panel.
To Next Page
Loading...
Need help?
General