NF ZM2371 - Page 190

5.6 Command Explanation
5-63 ZM2371/ZM2372
[:SENSe][:FIMPedance]:CONTact:VERify {ON|OFF|1|0}
[:SENSe][:FIMPedance]:CONTact:VERify?
Description: Sets/queries whether the contact check is used or not.
Parameters: {ON|1} Enables the contact check function.
{OFF|0} Disables the contact check function.
Setting example: :CONT:VER ON
Sets so as to enable the contact check.
Response: {1|0}
Query example: :CONT:VER?
Response example: 1
The contact check is enabled.
Remarks: The contact check can be used for the ZM2372 only.
An error will occur for the ZM2371.
[:SENSe][:FIMPedance]:CONTact:RVERify {ON|OFF|1|0}
[:SENSe][:FIMPedance]:CONTact:RVERify?
Description: Sets/queries whether real time check is used or not when the contact
check is executed.
Parameters: {ON|1} Enables the real time check.
{OFF|0} Disables the real time check.
Setting example: :CONT:RVER ON
Sets so as to enable the real time check.
Response: {1|0}
Query example: :CONT:RVER?
Response example: 1
The real time check is enabled.
Remarks: The contact check can be used for the ZM2372 only.
An error will occur for the ZM2371.