Nice HySecurity SlideSmart HD - Aligning the Chain

ALIGNING THE CHAIN
1. For a front installation, feed the chain over the
sprocket and beneath the idler wheels. See
Figure 11.
2. For a rear installation, see Figure 6.
3. In either situation, make sure the chain is
properly aligned horizontal to the ground and
parallel to the gate.
Figure 11. Rear View Chain Installation - Front View
SPROCKET
IDLER
WHEEL
Keep chain
horizontal
to the
ground
TARGET
SENSOR
(RH GATE)
TARGET
SENSOR
(LH GATE)
INSTALLATION
Figure 12. Correct Rear View Chain Installation
Figure 13. Incorrect Rear View Chain Installation
Chain to gate
Ideal distance =
2
1
/
4
" - 3
1
/
2
"
(5.72 - 8.9 cm)
CORRECT INSTALLATION
TOP VIEW
Too close to gate
INCORRECT INSTALLATION
Figure 14. Side View Chain Installation
CORRECT
INCORRECT
INCORRECT
SIDE VIEW
SlideSmart HD Programming and Operations
2222
support.hysecurity.com