Installation Considerations
Manual # 42-02-1P28 A3 2-5
Recommended Tools and Test Equipment
For proper installation, use the following tools and test equipment:
• A digital multimeter, Fluke series 75, 76, 77 or equivalent
•A clamp-on AC ammeter
• Hand-held radios or cell phone
•Test weights
• Pressure gauge
• Soldering tools, a flashlight and a screwdriver
Wiring Prints
Become familiar with the following information as well as the wiring prints provided with this
control system.
Drawing Number Format
Each print has a drawing number indicated in the title block. The drawing number is com-
prised of the job number, car number and page number (see example). In this manual the draw-
ings will often be referred to by the last digit of the drawing number (page number). The
following is the drawing number format currently in use.
Drawing Name: Some drawings have a drawing name directly above the title block or at the
top of the drawing. The drawing name may be used to refer to a particular drawing.
To Next Page
Loading...
Need help?
General
