Final Adjustment
4-12 Manual # 42-02-1P28 A3
Final Testing, LS-EDGE Only
Bottom Terminal Slowdown Limit Tests
To test the Normal Stopping Means
1. Remove the wires from terminals LIM0 and LIM1 on the HC-CTL2 board.
2. Apply 24VDC to the LIM0 and LIM1 terminals.
3. Under CONFIG 2 > HOISTWAY SETUP, note the Floor Step Down XX distance (XX
represents the bottom landing).
4. Move the car up and then make a call to the bottom landing.
5. Verify that the Fast Valves are disabled at the Floor Step Down XX distance and car
slows down.
To test the Terminal Speed Reducing Device
1. Make sure wires are placed back into terminals LIM0 and LIM1, and 24VDC is removed.
2. Under CONFIG 2 > HOISTWAY SETUP, note the Floor Step Up XX distance. Set it to
0 (zero) to disable it.
3. Move the car up and then make a call to the bottom landing.
4. Verify that the Fast Valves are disabled and car slows down near the bottom terminal
floor.
5. Restore original settings.
Top Terminal Slowdown Limit Tests
To test the Normal Terminal Stopping Means
1. Remove the wires from terminals LIM2 and LIM3 on the HC-CTL2 board.
2. Apply 24VDC to the LIM2 and LIM3 terminals.
3. Make sure under CONFIG 2 > NTS SWITCHES, the USL/DSL 3 option is disabled.
4. Under CONFIG 2 > HOISTWAY SETUP, note the Floor Step Up YY distance (YY rep-
resents the top landing).
5. Move the car down and then make a call to the top landing.
6. Verify that the Fast Valves are disabled at the Floor Step Up YY distance and car slows
down.
To test the Terminal Speed Reducing Device
1. Make sure wires are placed back into terminals LIM2 and LIM3, and 24VDC is removed.
2. Under CONFIG 2 > HOISTWAY SETUP, note the Floor Step Up YY distance. Set it to
0 (zero) to disable it.
3. Make sure under CONFIG 2 > NTS SWITCHES, the USL/DSL 3 option is disabled.
Move the car down and then make a call to the top landing. Verify that the Fast Valves
are disabled and car slows down near the top terminal floor.
4. Restore original settings.
To Next Page
Loading...
