Installation
2-6 Manual # 42-02-1P28 A3
Nomenclature
A listing of PC boards and their designator numbers plus other schematic symbols used in the
wiring prints can be found at the beginning of the Job Prints and in the Component Nomencla-
ture table below.
• Become familiar with the Elevator Car Wiring Print drawing number -1.
• Become familiar with the Elevator Hoistway Wiring Print drawing number -2.
• Become familiar with page -2DI of the job prints for duplex interconnect wiring if this
application is duplexed.
• Review any additional wiring diagrams and details.
• The remainder of the job prints are detailed drawings of the Motion 2000 TS Hydraulic
Control system.
The following table lists MCE part numbers and provides a brief description for each. Your
installation may not use all boards listed.
To Next Page
Loading...
