Nidec MCE Motion 2000 Touch Screen - MC-LSI Landing System Interface Board; LSI Connections

Troubleshooting Reference
Manual # 42-02-1P28 A3 5-41
5
MC-LSI Landing System Interface Board
The MC-LSI provides a connection point for the landing system and for the Car Panel Interface
board (MC-CPI-2) if one is used. The board receives 24 VDC power from an external power sup-
ply operating off the controller 2 Bus (120 VAC). In turn, the LSI board provides power to the
landing system and to any Universal I/O boards that might be used on the cartop through the
CAN connections to those components. A shielded, external CAN connection runs from the LSI
board, through the traveler, to the Motion 2000 controller. There are additional, discrete con-
nections through the traveler if the system is TSSA compliant and uses the LS-EDGE landing
system.
Figure 5.6 MC-LSI Landing System Interface Board
LSI Connections
• Local CAN: CAN and power to additional cartop box boards (HC-UIO-2, MC-CPI-2, etc.)
•CAN to Machine Room: CAN connections to/from machine room
• Landing System: CAN and DISC connections to/from landing system
• Door Signals from cartop HC-UIO-2:
• NDRI: Nudging, rear NDFI: Nudging, front
• DORI: Door open, rear DOFI: Door open, front
• DCRI: Door close, rear DCFI: Door close, front
• Door Signals to operators:
• NDR: Nudging, rear NDF: Nudging, front
• DOR: Door open, rear DOF: Door open, front
• DCR: Door close, rear DCF: Door close, front
• COMR: Common COMF: Common
• Landing System to Controller, Additional: See Job Prints
Local CAN connections to other car boards
Landing System
ELGO and
LS-EDGE
24 VDC
from cartop power supply
Door control signals from HC-UIO-2 board
Door control signals to
operators
CAN to
Machine
Room
Landing System
LS-EDGE TSSA
Landing system to
controller. See spe-
cific job prints.