M2000 TS Description
1-24 Manual # 42-02-1P28 A3
Menu Overview
Table 1.5 Config 01, 02, and 03
Topic Description
Config 01
Building Setup Controller type, floor information, Fire code and recall floors, landing system
type.
Job Info and Labels Job information, car and floor labels
Elevator Features Capture and recall floors, car behavior, anti-nuisance
Configure Spare Inputs Configure spare inputs.
Configure Spare Outputs Configure spare outputs.
System Timers Motor delays, door timers, car delay timers
Config 02
Hoistway Setup LS-EDGE landing system only.
Door Operation Door opening and closing
NTS Switches NA for hydraulic elevators
ETS Switches NA for hydraulic elevators
S-Curve NA for hydraulic elevators
System Control Parameters Car speed, valve, and starter settings
Config 03
Building Security Security settings
Emergency Power Power type, recall and run selections
Recall Switches Recall switch settings
Network Settings IP address information
CFSS Medical Emergency
Additional Features Sabbath Enable, etc.
Table 1.6 Utilities
Topic Description
File Transfer Allows you to selectively transfer controller parameters:
- Backup Current Settings
- Restore Backup Settings
- Restore Factory Settings
Register Calls Car and hall call registration
Construct and Bypass
Faults
Enable Construction mode/fault bypass. Set fault bypass for Inspection and
Automatic modes.
Safety Tests Commissioning tests
Date and Time Set date and time
Landing System Utilities Hoistway learn and landing system leveling data.
Table 1.7 System I/O
Topic Description
System Inputs View system input status
System Outputs View system output status
Programmed Inputs View programmed input status
Programmed Outputs View programmed output status
Front CPI I/O Status View main CPI board I/O status
Rear CPI I/O Status View aux CPI board I/O status
To Next Page
Loading...
