Hoistway Control Equipment Installation
Manual # 42-02-1P28 A3 3-15
LS-EDGE Terminal Magnets
Special striped magnets are used to designate the top and bottom terminals. The length of the
terminal magnets depends upon car speed, the aggressiveness of the slowdown, and the travel
distance between level at floor and end of travel.
Figure 3.8 Motion 2000 TS Bottom Terminal Magnets
1. Refer to Table 4 on page 16 to determine the length of the magnet to be placed above the
bottom terminal DZ magnet to the left of the tape holes.
2. Place magnets on the tape to the left of the holes, below the bottom terminal DZ magnet,
sufficient to allow the car to reach bottom travel limit while still sensing the magnet.
3. Refer to Table 4 on page 16 to determine the length of the magnet to be placed below the
top terminal DZ magnet to the right of the tape holes (see Top Terminal Magnets
Table 3.9 on page 16).
4. Place magnets on the tape to the right of the holes, above the top terminal DZ magnet
sufficient to allow the car to reach stop ring while still sensing the magnet.
40-11-0028
40-11-0028
40-11-0027
To Next Page
Loading...
