NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M100 Tow Tractor Manual No. 46052
PAGE 36
CHAPTER 2 MAINTENANCE
NOTICE!
dipstick to insure that no dirt or debris enters the system.
3. After wiping the dipstick clean, check the oil level. If the oil on the dipstick is
within the COLD RUN band, it is safe to operate the transmission until the
oil is hot enough to perform a HOT CHECK.
5. Perform a HOT CHECK as soon as possible.
Hot Check Procedure
1. Operate transmission in drive range until normal operating temperature is
reached:
160-200º F (71-93º C.) sump
180-220º F (82-104º C.) convert.-out
2. Park the tractor on a level surface, apply parking brake, and allow engine
to idle.
dipstick to insure that no dirt or debris enters the system.
3. After wiping the dipstick clean, check the oil level. The safe operating level
is anywhere within the HOT RUN band.
Fluid and Filter Change
Figure 10
At each oil change, examine the oil that is drained for evidence of dirt, metal
particles, or engine coolant contamination. If there is evidence of
contamination, tag out machine and inform your supervisor.
NOTICE! If excessive metal contamination occurred, replace the oil cooler
and bearings in the transmission. If coolant contamination is evident,
disassemble, clean, and inspect or serious damage may occur.
1. To assist draining, operate transmission to warm it up to operating
temperature.
2. Park the tractor on a level surface, shift to neutral, apply parking brake, and
chock wheels.
APRIL 15, 2012
1 SERVICING
To Next Page
Loading...
