EasyManua.ls Logo

NMC-WOLLARD 100 - Page 95

NMC-WOLLARD 100
848 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M100 Tow Tractor Manual No. 46052
PAGE 27
CHAPTER 2 MAINTENANCE
1 SERVICING
APRIL 15, 2012
3. 
smell. This would indicate damaged bands or clutches. If oil has a milky
look, water has entered the transmission. Air bubbles mean there is an air
leak in the suction lines. Report any of these conditions to your supervisor.
4. 
between “FULL” and “ADD 1 PINT” marks on the dipstick. See 1.3, Fluids
And Capacities.
Transmission Service - C6
The Ford C6 transmission combines a torque converter with a two-speed or
three-speed, fully automatic unit for transmitting engine torque to the drive

the recommended service intervals and adjusting the linkage, intermediate
band and the neutral start switch.
Removal and installation procedures are included in the event the
transmission must be replaced or sent to a specialized repair facility.
Malfunctions
Automatic transmission malfunctions may be caused by poor engine
performance or improper transmission adjustments.

and condition, and gearshift cable adjustment.
If the problem exists after these checks and adjustments are completed,
remove tractor from service and refer the transmission to a transmission
repair facility.
NOTICE! If you ever notice unusual noises such as gear noise or grinding,
a buzz or whine, knocks, scraping, clicking, etc., remove the tractor from
service and refer it to a transmission repair facility.
Transmission Adjustments for C6
Most repair facilities can perform intermediate band and neutral start switch
adjustments.
NOTICE! When making band adjustments, FOLLOW SPECIFICATIONS
EXACTLY. Failure to do so may cause serious damage to the transmission.
The intermediate band may need to be occasionally adjusted to compensate
for normal wear. Adjust band at every transmission oil change.

Table of Contents

Related product manuals