Quality of Service Guide Service Egress and Ingress QoS Policies
Edition: 01 3HE 11014 AAAC TQZZA 315
6.4.2.1.8 Service Ingress QoS Policy Forwarding Class Commands
broadcast-queue
Syntax broadcast-queue queue-id
no broadcast-queue
Context config>qos>sap-ingress>fc
Description This command maps the broadcast forwarding type queue to the fc fc-name. The specified
queue-id must already have been created within the policy before the mapping can be made.
Once the forwarding class mapping is executed, all broadcast traffic on a SAP using this
policy will be forwarded using the queue-id.
The no form of the command sets the broadcast forwarding type queue-id back to the default
of no mapping to an FC.
Default no broadcast-queue
Parameters queue-id — an existing queue defined in the config>qos>sap-ingress context.
Values 1 to 8
de-1-out-profile
Syntax [no] de-1-out-profile
Context config>qos>sap-ingress>fc
Description This command, when enabled on a parent forwarding class, applies a color profile mode to
the packets stored in the queue associated with this forwarding class.
When this QoS policy is applied to the ingress of an FR VLL SAP, DE=1 frames are classified
as out-of-profile and are not subject to the CIR marking.
All received DE=0 frames that exceed the CIR are marked as out-of-profile and have the DE
set to 1, regardless of whether this command is enabled or disabled.
The priority option, if used, has no effect. All FR VLL DE=1 frames have their priority
automatically set to low; DE=0 frames have their priority set to high.
All other capabilities of the Fpipe service are maintained. These capabilities include re-
marking of the DE bit on egress SAP, and FR PW control word on egress network port for the
packets that were classified as out-of-profile at the ingress SAP.
The de-1-out-profile command has an effect only when it is applied to the ingress of a SAP
that is part of an Fpipe service.
To Next Page
Loading...
