QoS Shapers and Shaper QoS Policies
454
Quality of Service Guide
3HE 11014 AAAC TQZZA Edition: 01
10.4.2.1.2 Shaper QoS Policy Commands
shaper-policy
Syntax shaper-policy policy-name [create]
no shaper-policy policy-name
Context config>qos
Description This command enables the context to configure a shaper QoS policy.
For hybrid ports, the shaper policy is independently assigned to access or network egress
traffic. When the Ethernet port mode is changed to hybrid mode, the default policy is assigned
to access and network traffic. To change an access or network policy, use the commands
config>port>ethernet>access>egress>shaper-policy and config>port>ethernet>
network>egress>shaper-policy.
For access ingress per-customer aggregate shaping, the shaper policy is assigned to an
Ethernet MDA, and SAPs on that Ethernet MDA must be bound to a shaper group within the
shaper policy bound to that Ethernet MDA. To assign a shaper policy to an adapter card, use
the command config>card>mda>access>ingress>shaper-policy.
For access egress per-customer aggregate shaping, the shaper policy is assigned to a port,
and SAPs on that port must be bound to a shaper group within the shaper policy bound to
that port. To assign a shaper policy on egress, use the command config>port>ethernet>
access>egress>shaper-policy.
The default shaper policy cannot be deleted. Table 66 displays the default shaper policy
parameters.
The no form of this command removes the configured shaper-policy.
Default shaper-policy “default”
Table 66 Shaper Policy Defaults
Field Default
description “Default Shaper QoS policy.”
shaper-group “default”
description “Default Shaper Group.”
pir-rate max
cir-rate 0
To Next Page
Loading...
