Quality of Service Guide QoS Shapers and Shaper QoS Policies
Edition: 01 3HE 11014 AAAC TQZZA 455
Parameters policy-name — the name of the shaper policy. To access the default shaper policy, enter
“default”.
Values Valid names consist of any string up to 32 characters long
composed of printable, 7-bit ASCII characters.
If the string contains special characters (#, $, spaces, etc.), the
entire string must be enclosed within double quotes.
create — keyword used to create a shaper policy
shaper-group
Syntax shaper-group shaper-group-name [create]
no shaper-group shaper-group-name
Context config>qos>shaper-policy
Description This command creates and configures a shaper group. A shaper group is a dual-rate
aggregate shaper used to arbitrate shaped and unshaped traffic for SAPs (access) and for
VLANs (network).
The default shaper group cannot be deleted.
The no form of this command removes the configured shaper-group.
Default shaper-group “default”
Parameters shaper-group-name — the name of the shaper group. To access the default shaper
group, enter “default”.
create — keyword used to create a shaper group
rate
Syntax rate pir-rate [cir cir-rate]
no rate
Context config>qos>shaper-policy>shaper-group
Description This command sets the PIR and CIR for the shaper group. When the PIR or CIR is set to max,
the corresponding aggregate shaper rate is capped at the egress-rate configured on the port
(config>port>ethernet>egress-rate).
The no form of this command restores the pir-rate and cir-rate to the default values.
Default pir-rate: max
cir-rate: 0
To Next Page
Loading...
