Operating & Maintaining the Eden 3-D Printer
7–12
DOC-00500 Rev. F
TheEdenprinterbeginstheprocessoffillingtheprintheadswiththe
newmodelmaterial.Thismaytakeupto15minutes.
Figure 7-15: Resin replacement: filling heads with new model material
11. Whenthefinalwizardscreenappears,clickDonetoclosethewizard.
CAUTION: Dispose of cartridges of Eden model and support material in
accordance with all applicable laws and regulations. If necessary, the
cartridges can be disassembled for recycling. If this is done, protect the
person handling the cartridges from direct exposure to uncured resins.
To Next Page
Loading...
