Objet Eden500V - Page 87

DOC-00500 Rev. F 7–11
Eden500V/350V/350 User Guide
7. ClickNext,andtakenoteofthewarningscreen.
Figure 7-13: Resin Material Replacement warning screen
8. Tocontinue,clickNext.
9. Whenpromptedbythewizardscreen,removethemodel‐material
cartridge(s).Selectthecheckboxtoconfirmthatyouhavedoneso,and
click
Next.
10. Whenprompted,insertthenewcartridge(s)ofmodelmaterial.Select
thecheckboxandclickNext.
Figure 7-14: Prompt to insert new right-hand model cartridge
Once you start this procedure, you must complete it before you can produce
models with the Eden printer. To perform the procedure at another time,
click Cancel. If you continue (by clicking Next) and you do not complete the
procedure, you must start the Resin Replacement wizard again (see step 1
on page 8) before producing models.